My Garage Door Operator is an older model . Am I able to get a Keyless Entry that will work with my operator?
Yes. Liftmaster has a Universal Keypad which works with the older frequencies and is compatible with most older machines.
Do you sell remotes for older machines?
Yes. Liftmaster has a Universal Remote which works with the older frequencies and is compatible with most older machines.
My keyless Entry does not work.
Either your battery needs to be replaced or the sensors on the key pad have worn out and the keyless entry needs to be replaced. Sometimes you can extend the life of your keypad by choosing a [...]
My remotes don’t work.
It is possible that the batteries need to be replaced. Also, check to see that the security lock feature on the wall switch has not been turned on. If the LED light on the wall switch is blinking [...]
My door won’t close and the lights on the opener blink off and on.
The infrared safety sensors are out of alignment, obstructed or faulty. The sensors are located about a foot up from the bottom of the track on either side of the door. Both lights should be [...]
My Garage Door does not close all the way or sometimes it hits too hard.
Your travel limit needs to be adjusted.
What is the difference between a belt drive and a chain drive Opener?
A belt drive operator is much quieter (silent) as opposed to a chain drive operator.
All of a sudden my remotes, my keyless entry pad & the wall switch don’t work, what could this be?
Your logic board needs to be replaced.
My Garage Door Opener makes a humming sound and the door does not open, what is this?
You have a burned out motor start capacitor.
The trolley is moving but it is not lifting the door, why?
Your emergency release has been disconnected. To reconnect your emergency release pull the red handle forward towards the door to reset the catch then either lift the door to reconnect it or [...]